Multiple openings can be machined into a single steel bar. These dies are typically used to replace single-vee dies and can significantly reduce die-change time.
NOTE: Unless specified, all three-way dies are furnished with the smallest vee opening of 60 degrees.
Please type your preferred length: ft
Flame Hardening:
Yes
No
Three Way Dies - Illustration D
Multiple openings can be machined into a single steel bar. These dies are typically used to replace single-vee dies and can significantly reduce die-change time.
NOTE: Unless specified, all three-way dies are furnished with the smallest vee opening of 60 degrees.
Please type your preferred length: ft
Flame Hardening:
Yes
No
FT36-FT37
30° - 60° LAYOUT FOR DEEPER BOX
Please type your preferred length: ft
Flame Hardening:
Yes
No
F128-F129; F128S-F129S and F400R
The F128-F129 set is used to form a tube in a successive number of strokes. The peripheral suface of the form may show evidence of this. To accommodate the required height, a No. F400R adapter must be used. The F128S-F129S set is normally furnished about two feet long. The pre-formed tube is fed thru the die from left to right, sizing the part in two-foot increments. Any length of part can be sized in this manner.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F160-F161 and F162-F163
For high-production flanging operations, the F160-F161 or F162-F163 set is recommended. These dies hold the sheet flat while wiping a 90 degree flange either up or down. Back gauging can be easily fitted to the F160-F161 set, although the sheet will move approximately 1/2" down with the spring pad. The sheet does not move down when using die set F162-F163; however, front gauging is best suited for this operation. Maximum capacity recommended for the illustrated dies is 16 gauge, although heavier construction will allow forming up to 12 gauge.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F164-F165
When wiping a radius on the edge of a sheet, the F164-F165 set is recommended. Overbend allowance is built into the die set to compensate for springback. Maximum capacity for the die set shown at left is 16 gauge.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F168-F169
The F168-F169 set is designed to produce closed-flange forms. When the die opens, the heel travels up, making it possible to remove the formed sheet.
