1029/A/85°

1010/A/88°/0.8/105

1010/A/75°/0.8.105

1030/A/88°/0.8

1032/A/88°/0.8

Press Brakes & Punch Press Applications

CLAMP: Material is securely clamped without other holddowns. No skidding.

Bend: The sheet always stays level. Faster bending with improved safety and consistency.

Overbend: Rotor bends beyond 90° to allow for springback. Overbend rotors can bend to 120° in one press stroke.

Standard Rotary Die

Increase Your Productivity and Quality

Due to the special nature of this product, a consultation is required prior to ordering. Please call to discuss.

Bend Types

For Press Brakes & Punch Press Applications

Due to the special nature of this product, a consultation is required prior to ordering. Please call to discuss.

4006

H = 34 mm

F120-F121

The F120-F121 set can be used to increase the rigidity of a flat sheet by forming one or more ribs. Overbend allowance is built into the set to allow for springback.

F250-F251

Die sets F250-F251 and F252-F253 are recommended for 18 gauge and lighter because of the side thrust on punch caused by tipped forming angle.

Die set F250-F251 has a tipped forming angle to minimize sheet whip up and provide ram clearance on deep channel forming done in two strokes.

4006/A

F198-F199

The F198-F199 set produces a V rib in one stroke. For heavy-gauge metals, the die can be relieved to reduce the tonnage, but some accuracy will be lost.

F252-F253

Die sets F250-F251 and F252-F253 are recommended for 18 gauge and lighter because of the side thrust on punch caused by tipped forming angle.

Die set F252-F253 has tipped angle to strengthen gooseneck caused by clearance required for deep return flange.

4007

H = 55 mm

F254-F255

Die set F254-F255 forms three bends in one stroke. Consult our engineering department for tonnage requirements.

F256-F257

When flange on 90 degree bend is too short to permit forming on standard vee dies, die set F256-F257 is recommended. Forming angle is tipped and dies are heeled to prevent spreading.

4007/A

H = 45 mm

4008

H = 75mm

F300-F301

In making rectangular tubes, die sets F300-F301 are often used as a progressive combination. A slight curvature can be expected on the formed side but, whether it is convex or concave , can be controlled in the forming.