Rocker dies are designed to produce multi-form shapes such as U channels, edge channels and contour shapes in a single stroke. Rocker dies are typically limited to 16 gauge and lighter material.
The F175-F176 knuckle assembly allows for movement of the punch, resulting in better alignment with and release from the bottom die. This assembly can be used with any of the punch profiles shown below.
The F177-F178 set forms a U channel in one stroke. Springback allowance is built into the die set.
Please type your preferred length: ft
Flame Hardening:
Yes
No
1014/88°/0.8/6
F175A
Flush rocker F175A is used when projected ends shown below would interfere with formed flanges.
Please type your preferred length: ft
Flame Hardening:
Yes
No
1014/A/75°
F179-F180
The F179-F180 set produces a square channel in one stroke. If excess material is trapped in the die, some irregularity may be noticed in the bottom of the channel.
Please type your preferred length: ft
Flame Hardening:
Yes
No
1014/90°
F181-F182
The F181-F182 set produces a radius bend and return flange in one stroke. This set is not recommended for a radius larger than 1".
