When forming a shallow open-angle offset in the middle of a sheet, the F78-F79 set is recommended. Large radii and maximum relief help reduce press brake requirements. Dies F78A-F79A are used to bottom form open-angle offsets.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F80-F81
If press brake capacity will not permit a bottoming offset operation, comparatively good results can be obtained by air forming with the F80-F81 set. Some accuracy will be lost. Heavy-duty offset bottoming-type dies are available in die numbers F80A-F81A (not shown).
Please type your preferred length: ft
Flame Hardening:
Yes
No
4018
F50-F51
The F50-F51 set is a form fitting radius die set with spring-back allowance built in. It is manufactured to form a specific type and thickness of material for maximum accuracy.
Please type your preferred length: ft
Flame Hardening:
Yes
No
4015
F54-F55
The F54-F55 set is used to radius the edge of a sheet prior to a rolling operation, thus eliminating the flat ends normally encountered.
Please type your preferred length: ft
Flame Hardening:
Yes
No
4016
F52-F53
On light gauges, where kinking is a problem, the F52-F53 set is recommended. The spring pad will prevent premature breakdown of stock.
Please type your preferred length: ft
Flame Hardening:
Yes
No
4017
L = 1050
H = 31
H = 61.5
F56-F57
Forming a radius on a sheet having a pre-formed return flange is accomplished by the F56-F57 die set provided there is a short flat distance between the return flange and end of radius.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F58-F59
The F58-F59 set must be used when the return flange starts at the end of the radius. The return flange must be pre-formed to an angle less than 90 degrees.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F60-F61
Out-turned flanges on radius bends can be formed with the F60-F61 radius set in one stroke if springback is not too great.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F62-F63
When forming a radius on a sheet that has up-turned flanges on the ends, the F62-F63 set is necessary. Female die has wiper plates on each end to hold the flanges square and prevent them from wrinkling during the forming operation. Length of punch and die must be held closely and consideration should be given to the difference in springback between the center and the ends of the workpiece.
Ram adapters are mounted to the press brake ram and are used to fill the die space if ram adjustment or stroke is insufficient. Ram adapters can be made any height or width to suit conditions and may be cut into sections for use in box forming.
Please type your preferred length: ft
Flame Hardening:
Yes
No
1016/a
* = 88°
= 90°
F401R
Ram adapters are mounted to the press brake ram and are used to fill the die space if ram adjustment or stroke is insufficient. Ram adapters can be made any height or width to suit conditions and may be cut into sections for use in box forming.
Please type your preferred length: ft
Flame Hardening:
Yes
No
1017/A/30°
F402R
Ram adapters are mounted to the press brake ram and are used to fill the die space if ram adjustment or stroke is insufficient. Ram adapters can be made any height or width to suit conditions and may be cut into sections for use in box forming.
