The F130-F131 set is a three-high hemming die set recommended for 18 gauge and lighter mild steel. Shimming under the adjustment angle on lower section will allow production of an open or closed hem. The F130A is shown with an equalizing back heel for higher production and heavier material.
Please type your preferred length: ft
Flame Hardening:
Yes
No
2011/40/85°
F34-F35
Dies F34 and F35 offer an inexpensive alternative for hemming 18 gauge and lighter material. This set will require two strokes to bend and close the hem.
Open-angle offsets up to 5/16" can be produced using the F82-F83 set. Shimming behind reversible blocks changes the depth of the offset. Rotation of the blocks changes the radius. Each corner has a different radius to allow for various material thicknesses.
Please type your preferred length: ft
Flame Hardening:
Yes
No
1022/A/75°
F84-F85
If the offset is 1" or less from the edge, the F84-F85 set can be used. This die set has a back-up leader to minimize spreading, resulting in sharper offsets.
Please type your preferred length: ft
Flame Hardening:
Yes
No
1022/A/88°
F86-F87
Material-thickness offsets are performed on the F86-F87 set. When necessary, a back-up leader and gauging are provided.
Please type your preferred length: ft
Flame Hardening:
Yes
No
1023/A/88°
F88-F89
On heavier gauge stock, material-thickness offsets will always be of the open-angle form similar to F88-F89 because the outside radii are too large for the depth of the form.
