2012/90°

F40

Safety tangs or hook tongues are recommended on punches of this size to prevent dropping out when ram plates are loosened.

2012/A/90°

F38 and F39

The special gooseneck punches shown may be used to form boxes and channels with long return legs. Die F39 can be fastened directly to press bed.

2013/90°

F36 and F37

When forming a four-sided box, the punch must be tall enough to prevent the preformed sides from striking the ram.

2013/A/90°

2014/88°

2014/A/88°

2015/88°

2015/A/88°

2016/90°

2017/90°

Standard Sectioning for 835mm Dies

    Top

2019/A/90°

F132-F133

The F132-F133 set eliminates whip-up and is highly recommended for high-production hemming of large sheets. The initial operation (shown left) produces the acute bend. The second operation flattens the hem between the punch anvil and the spring-loaded pad in the die. This set is normally used to form 20 gauge and lighter material. It can be modified to form 18 gauge by extending the punch anvil and adding an adjustable forming angle. Maximum hem length is 3/4".

2020/A/90°

F170-F171

Edge and return bends can be made in one operation with the F170-F171 set. This die permits return-bend forms with a single press stroke without whip-up of the sheet. To insure satisfactory operation, the return-flange dimension must be held to a minimum.

2021/A/90°

2022/A/88°