Closed curls of 1/2" inside diameter and larger can be produced with die sets F100-F101 and F102-F103 in three strokes. Open curls up to 200 degrees can be produced in die set F100-F101 alone, in 2 operations.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F104-F105 and F106-F107
Die sets F104-F105 and F106-F107 form a curl over a wire core or mandrel in 3 operations. There may be a slight flat on the curl along the closing edge for sets shown on this page.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F108-F109
An off-center curl is completed in 3 strokes in die set F108-F109. Curls may range in size from 1/4" diameter to 3/4" diameter in 16 gauge and lighter stock. This type of curling die can be furnished without heels; however, we do not recommend this practice.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F110-F111
Off-center curls are performed in 3 strokes in die set F110-F111 and on-center curls in 4 strokes. On-center will not be perfectly round unless a mandrel is used in the last operation. Curls may range in size from 1/4" inside diameter to 3/4" inside diameter in 16 gauge and lighter. The range can be increased slightly if a mandrel is used.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F112-F113 and F114-F115
Die sets F112-F113 and F114-F115 produce the tightest and roundest curl that can be formed in two strokes within the range of 3/16" to 3/4" inside diameter. Dies can be mounted side by side for progressive forming if the press has sufficient length. In forming heavy gauge material, it is advisable to add a tool steel insert.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F114C-F115C
Die set F114C-F115C produces an on-center curl in an extra stroke. The roundness of the on-center curl becomes somewhat distorted unless a mandrel is used in the last operation.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F116-F117 and F118-F119
Die sets F116-F117 and F118-F119 should be considered when a highly accurate on-center curl is desired. These dies may be used to produce a curl from 1/4" to 1/2" inside diameter in light gauge material. A minimal flat appears on the lead edge and the sheet remains relatively flat during the forming operation. The sheet to be formed must be wide enough to provide for a reasonable amount of stock to extend in front of the die sets for safe feeding of the part.
