For high-production flanging operations, the F160-F161 or F162-F163 set is recommended. These dies hold the sheet flat while wiping a 90 degree flange either up or down. Back gauging can be easily fitted to the F160-F161 set, although the sheet will move approximately 1/2" down with the spring pad. The sheet does not move down when using die set F162-F163; however, front gauging is best suited for this operation. Maximum capacity recommended for the illustrated dies is 16 gauge, although heavier construction will allow forming up to 12 gauge.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F164-F165
When wiping a radius on the edge of a sheet, the F164-F165 set is recommended. Overbend allowance is built into the die set to compensate for springback. Maximum capacity for the die set shown at left is 16 gauge.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F168-F169
The F168-F169 set is designed to produce closed-flange forms. When the die opens, the heel travels up, making it possible to remove the formed sheet.
