A semi-hat-shaped channel can be formed on the edge of a sheet with the F184-F185 set. The release wedge and hook stripper assure positive part removal.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F200-F201
The F200-F201 set forms four square bends in one stroke. The spring pad in the die keeps the web flat. Release wedges in the punch and die permit easy removal of the part.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F186-F187
The F186-F187 set can be used to form flat-bottomed channels in one stroke. Stripping is assured with release wedges and hook strippers.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F204-F205
By tapering sides of the channel, the design of the F204-F205 set is simplified and the cost reduced. A pressure pad in the lower die holds the material against the punch and maintains web flatness. It also serves to eject the part.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F190-F191
Channels with a web width of 3/4" or less are usually formed in a die set such as the F190-F191. Spring pads may be used if web width allows.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F192-F193
For channels with web width over 3/4", the F192-F193 set is recommended. Both punch and die have release wedges for quick removal of part. The die has a pressure pad to help maintain accuracy and keep the web flat.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F194-F195
When considerable material springback is encountered in channel forming and over-bending is necessary, the F194-F195 set is recommended. The spring pad actuates the rocker inserts, causing over-bending near the bottom of the stroke.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F196-F197
Small U channels with little spring-back can be formed in one stroke in the F196-F197 set. The rocker insert over-bends the shape to compensate for springback.
