When forming an acute-angle offset at the edge of a sheet, the F70-F71 set has the least tendency to spread. Capacity should be limited to 20 ga.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F76-F77
When forming large offsets, the best results are obtained with a die set such as the F76-F77. The forming angle is tipped to prevent bowing of the offset web.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F78-F79
When forming a shallow open-angle offset in the middle of a sheet, the F78-F79 set is recommended. Large radii and maximum relief help reduce press brake requirements. Dies F78A-F79A are used to bottom form open-angle offsets.
Please type your preferred length: ft
Flame Hardening:
Yes
No
F80-F81
If press brake capacity will not permit a bottoming offset operation, comparatively good results can be obtained by air forming with the F80-F81 set. Some accuracy will be lost. Heavy-duty offset bottoming-type dies are available in die numbers F80A-F81A (not shown).
